Field notes: the shadow that gave away a boom height

Silhouettes of tall ship-to-shore container cranes against an orange sunset sky above a harbor.

A few weeks ago I was running height checks on a row of ship-to-shore cranes at a terminal that had just taken delivery of new units, the kind of job where you're trying to confirm whether the boom on the new crane clears the stated air draft or whether the spec sheet rounded up. The imagery was good, sub-half-meter GSD, clean nadir pass, no cloud shadow across the apron. But the crane in question was angled slightly off the capture line, and the boom tip sat right at the edge of a stitching seam between two image tiles. The pixel count across the boom gave me a number I didn't fully trust.

So I did what you do when the direct measurement is shaky: I went to the shadow.

The crane was parked with its boom raised, late morning, sun still low enough in that latitude to throw a long shadow across the yard pavement rather than straight down under the machine. You could trace the boom's shadow almost to the base of an adjacent rail-mounted gantry, a nice coincidence because the gantry's rail gauge was already known from an earlier survey and gave me a hard scale reference sitting right next to the shadow. Measure the shadow length, pull the sun elevation angle for that exact timestamp and latitude, and the trig is grade-school stuff: height equals shadow length times the tangent of the sun's elevation angle. Fifteen minutes of work gave me a boom height within a couple of pixels of the direct measurement, confirming the tile seam had thrown off my eye and the original pixel count was sound.

That's the part worth writing down: it's a reminder to doubt your own read before you doubt the crane's spec sheet. A shadow cross-check catches you misreading a boom edge against a background that's nearly the same tone, something that happens constantly on concrete aprons where the crane's gray and the pavement's gray sit about four shades apart.

The trick only works under conditions you have to check before you lean on it: a sun angle low enough to throw a shadow worth measuring, a shadow falling across flat ground rather than onto stacked containers or another piece of equipment, and a boom orientation close enough to perpendicular to the sun that you're not measuring a foreshortened shadow and calling it the real length. Get any of those wrong and the shadow method will hand you a confident, wrong number. I've seen a boom shadow cut across three container rows and come out looking twenty feet short because it was partly climbing up the side of a stack instead of lying flat.

None of this replaces the primary read. Photogrammetric height from the image geometry itself is still the first pass, every time, for every crane in the inventory. The shadow is a sanity check you reach for when the primary number sits near a tile boundary, near a cloud edge, or near anything else that makes you want a second opinion before you write a figure into a dataset someone's going to use to size up a competitor's fleet.

It's a small habit, but it's the kind of habit that separates a crane inventory someone can rely on from one that just looks complete. If you're the one building that terminal-by-terminal picture of who's running what across a market, the method matters as much as the coverage, and that discipline is baked into how we put together our own crane fleet inventory.

If a shadow-checked, terminal-by-terminal crane inventory would save your team the site visits, that's the job we built this for.

Start a pilot

Back to the blog